Securing shackles should be inspected for corrosion > 자료실

본문 바로가기

회원로그인


사이버홍보실

자료실

KLCSM와 관련된 다영한 자료를 모아 두었습니다. 필요하실때 다운로드 받아 사용하십시오.

Securing shackles should be inspected for corrosion

페이지 정보

작성자 최고관리자 댓글 0건 조회 12회 작성일 21-03-25 18:42

본문

Lessons learned: Securing shackles should be inspected for corrosion

Following the latest version of IMCA's Safety Flashes, it is described a case where during replacement of a lifeboat embarkation ladder, was identified a total failure of the natural fibre rope at the securing thimble.

Safety | 12/03/21 

        

The case

Planned inspection/replacement of a lifeboat embarkation ladder identified the total failure of the natural fibre rope at the securing thimble. The fibre rope at the anchor point securing thimble was worn through due to incorrect connection creating the potential for ladder failure on deployment.

 

Although natural fibre rope has properties that make it ideal for use in many marine applications, it is particularly susceptible to damage and loss of strength for several reasons, if it is not stowed and handled correctly.

Findings

According to IMCA:

Investigation found that the failure was caused through abrasion due to the back of the eye being in contact with the metal deck strong point. The anchor point was too small for the use of a shackle of enough size to provide clearance between the rope and deck strong point. The rope failed during removal of the ladder, indicating the extent of the wear.

Lessons learned

The inspection and maintenance of rope ladders should be part of the vessel planned maintenance schedule.

A thorough inspection should be undertaken on a regular basis, and a visual check before and after use.

The entire length of the ladder should be examined including all fixtures and fittings, considering the following points:

  • Although the surface of the rope may appear to be in satisfactory condition, natural fibre rope may self-abrade from the inside. The lay should be opened at regular intervals along the rope to check for signs of wear;

  • The presence of dark mould spots or a grey powdery substance within the lay of the rope may be an indication of rot or mildew, which is very difficult to eradicate;

  • If the fibres on the surface appear to be weak or frayed and can be picked away easily, the rope may be suffering from sunlight or chemical degradation;

  • Steps and chocks should be inspected for damage, cracks, wear, splits, sharp edges or splinters. Ensure slip resistant material applied to steps remains effective;

  • Securing shackles should be inspected for corrosion, for size and suitability and shackle pin secured by means of a split pin or similar arrangement;

  • Pad eyes should be inspected for damage or corrosion, and welds checked for excessive wear down or cracks.

What is more, damage to or degradation of a natural fibre rope should be evaluated by an appropriately experienced crew member.

 

If deemed necessary, or if any doubt exists, the ladder should be removed from service, repaired or replaced. Factors which may require such action could include:

  • Fraying, abrasion, cuts or signs of excessive wear;

  • Deterioration or damage caused by chemicals, detergent or paint;

  • Powdering between strands, rot or mildew;

  • Variations in diameter size;

  • Exposure to overloading or shock loads;

  • Kinks which are difficult to remove.

Shackles should be replaced if wear or corrosion has reduced the diameter of the crown or pin by more than 10%.

Pad eyes should be checked for cracks and excessive wear and be replaced or repaired in accordance with Class requirements.

 

 

그누보드5

부산광역시 중구 충장대로5번길 22 l Tel : 051-661-6100 l FAX : 051-661-6294

COPYRIGHT©2020 BY KLCSM CORPORATION ALL RIGHTS RESERVED.